starcharts.blogg.se - Melsoft gx works 2

#MELSOFT GX WORKS 2 SERIAL NUMBERS#

*The default value "10 minutes" means that it is impossible to communicate for 10 minutes after communication has been stopped. *The existence confirmation processing will be performed 3 times at 10 seconds intervals after communication has been stopped for 5 seconds. Sample settingĭestination existence conformation starting intervalĭestination existence conformation interval timerĭestination existence conformation resend It is necessary to configure the "Initial setting" as follow. You push the "Initial setting" button of Network parameter screen.

#MELSOFT GX WORKS 2 SERIAL NUMBERS#

Ethernet units that have serial numbers with 05051 or later as the upper five digits and function version B or later can use this function.For other models, use Ping.

The use of the Keep Alive function to perform existence checks is recommended when the Q Series is used.

It may become to impossible to reconnect PLC without PLC's reset,if you select the existence confirmation setting by PING.

Existence confirmation setting by PING is to send ICMP packet, Existence confirmation setting by KeepAlive is to send ACK packet.

Please check "Enable Write at RUN time", if you can write to PLC device from outside(OPC Server).

If you share a software which supports only ASCII code as like MX-Component, please use an automatic open UDP/IP port.

OPC Server doesn't support ASCII code communication.